THE TOPCOAT
All substrates · Failure

What causes orange peel? And why more thinner isn't always the fix

12 November 2026
Schematic card from The Topcoat: What causes orange peel? And why more thinner isn't always the fix

Orange peel is a coating surface that looks like the skin of an orange: a field of small, smooth bumps instead of a flat film. It's one of the most common things people notice on a freshly sprayed job.

What's actually happening

Spray paint lands as droplets. For a smooth film, those droplets have to flow together and level out before the paint gets too thick to move. Orange peel is what you get when the film stops flowing before it has levelled. The bumps are the droplets, frozen half-way.

So almost every cause comes down to one question: did the paint have enough time and freedom to flow?

The usual causes, roughly in the order I'd check them:

  1. The paint is too thick to flow. Viscosity too high at application: cold material, too little thinner, or the wrong thinner.

  2. The solvent leaves too fast. Hot steel, a hot or windy day, or a fast-evaporating thinner. The surface stiffens before it has levelled.

  3. Poor atomization. Pressure too low or the wrong tip, so the droplets are too big to level out. Go too far the other way and you get dry spray instead.

  4. Too much film in one pass. Thicker wet films keep moving while they cure, and that movement can get locked in as texture.

The twist: more thinner isn't an automatic fix

If the paint is too thick, thinner helps. But adding solvent can also make orange peel worse, because there's more solvent leaving the film while it sets. And every data sheet sets a thinning limit for a reason. Check temperature and the thinner type before reaching for more of it.

How to tell it apart on site

Does it matter?

On a car, yes: it blurs reflections, even when gloss looks fine. On most protective coating jobs, mild orange peel is cosmetic and doesn't change protection. Heavy texture is worth a closer look, because it usually means the application was off in other ways too.

Sources: CoatingsTech, Clifford K. Schoff, "Automotive coatings: application defects" (American Coatings Association); Michael Bonner, "Dissecting orange peel" (PCI Magazine, 2018); Corrosionpedia.

General information. The project specification and the product data sheet set the requirements for your job.

Discuss this on LinkedIn → · More in the library